Monday, January 25, 2010

Mariner Outboard, Edmonton Can Any One Help With Electrical Problem On 50hp Mariner Outboard?

Can any one help with electrical problem on 50hp Mariner outboard? - mariner outboard, edmonton

I have a 50 hp Mariner, which has an intermittent electrical fault.
Electric start and power tilt and trim. Although sometimes it is normally the starter just clicks like a starter motor disorders. At the same time, the links to complain to the slope and cut himself, but do not activate the device. The two failures occur simultaneously and are available only intermittently. All other facilities are good and we are working all the time, even if the starter is at fault. It is done something, but not enough to move to the starter. All batteries are fully charged.

I had the electrical system and controls all seemed well, although the error was obvious at the time. Maybe a ground could be on the engine, but everything seems okay.

No one had the same problem and can advise me where to start looking.

5 comments:

boatman said...

The attempt to thoroughly clean the battery terminals, though not always good to try another battery
Remove the spark plug before the engine will reduce the power of the starter.

William F. D said...

Looks like the battery terminals or cables are dirty.

jock said...

Go into the electrical system to isolate it, because it is a common mistake for poor inner connection. suggest the need to jump that are long enough to reach the starting battery so that if the debt can eliminate occusr some cases, if it happens to starter-run leads directly to see if the engine is started, unless it is to also eliminate defective nextby pass breaker if you see one, to see if it is defective Another common problem when the ignition key if you have not already put it into operation, the button to begin the hope that the guilt that a Intermittent faults are very difficult sport

blenyuk said...

I want to check the connections on the starter solenoid or change the internal contacts can be finely chopped or drained when the battery is fine and the ground is good that the only thing you could check to regain ground definatley be. But I no it looks like the most likely cause.

singer said...

The beginning and the seat and tilt channels are separate and should not participate in it indicates that you describe time.What starter, low voltage, which will be rebuilt due to low battery and / or dirty connections or a holder may be caused by or replaced connections. The most common cause in the maritime industry is loose and corroded

Post a Comment